055 valve face depth with a standard head gasket and a 99 intake centerline. On a 98 02 24v you will need no more than. 038 valve face depth with a standard gasket. On an 03 and up, it needs. 018piston protrusion and at least.
If you do not meet the minimum requirements for piston to valve clearance, dont worry, you can still run an oversize head gasket or cut valve reliefs. Although this is considered a drop in cam it is important to check clearances (You can use our clearance calculator to make it a little easier). We always recommend new lifters when changing a cam. Larger single, or set of compounds.To make sure that you have no issues during break-in, follow these few suggestions. Make sure that the cam has a Liberal amount of quality assembly lube applied. DO NOT let the engine start without oil pressure. When this is a new engine, be sure to put a liberal amount of assembly lube in the oil pump and prime the oil filter. Be sure to change the oil after you have done your break-in procedure. When the filter and oil system are already primed, engine will get oil pressure much faster than if the oil is changed at the same time. Disconnect the fuel system and spin the engine with the starter until oil pressure can be read or until oil is coming out of the rocker arms. Do not let the starter run for more than 10 seconds at a time. Adjust valves then you are cleared to abuse your engine. If you need to re-torque or hot-torque the head, do so before adjusting valves.
Re-torqueing the head changes the valve lash setting, so it is important to set lash last. We're the Experts Ask us anything. Price Match Guarantee We match advertised prices. There is a 30 day turnaround policy on cores from the time it was delivered.(determined by UPS tracking #). If a product arrives damaged please contact Dale's Super Store right away. Do not attempt to install a damaged item.
Colors may slightly vary based off of screen resolution and manufacturing differences. All DPF-OFF tuning products are strictly for race use only. Dale's Super Store does not condone or endorse illegal use of these products. We reserve the right to refuse a return if the seal on electrical parts are broken, installed or downloaded.
Custom Tuners such as EFI Live, TS, MCC Tuned H&S, are not available for return. The item "Hamilton Cams 188/220 Cast Camshaft For 89-18 Cummins 07-c-188/220" is in sale since Tuesday, September 3, 2019. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Engines & Components\Camshafts, Lifters & Parts".
The seller is "dalesperformance" and is located in Bradenton, Florida. This item can be shipped to United States, Canada, United Kingdom, Australia, Mexico, Germany, Japan, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Greece, Portugal, Cyprus, Slovenia, China, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Austria, Bahamas, Israel, New Zealand, Singapore, Switzerland, Norway, Saudi arabia, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay.